Role: {{ value }} Which best describes your role?

Your response helps us make our online experience better to provide content that is specific to your role.

Thank you. Your response helps us make our online experience better to provide content that is specific to your role.

Only a few accessories are needed to install the RubberCover EPDM system properly. These are available from Elevate and are very easy to use.

Discover our range of accessories:

QuickSeam Products

EPDM seaming products that facilitate the installation of the RubberCover EPDM membrane.

QuickPrime Plus

Designed to clean and prime the RubberCover EPDM membrane and/or substrate that are to receive a QuickSeam product.

QuickSeam Cover Strip

Semi-cured EPDM strip laminated to a QuickSeam tape. It is used to cover and seal butt-joined RubberCover EPDM membranes.

QuickSeam Corner Flashing

Round piece of uncured EPDM FormFlash laminated to QuickSeam tape. It is designed to flash outside corners or to be used as a cover patch where appropriate.

QuickSeam Pipe Flashing

Pre-fabricated pipe boot with a QuickSeam tape laminated to the bottom of its flange. Specifically designed for flashing rigid round penetrations and conduits of 25 mm to 152 mm.

QuickSeam SA Flashing

Non-reinforced 1.5 mm thick RubberCover EPDM membrane, fully laminated to QuickSeam tape. It is used to easily flash details where cured EPDM is required or preferred: curbs, parapets, gutters, general roof repairs, drain and pipe flanges.

Adhesives & cleaning agents

All you need for bonding and cleaning RubberCover EPDM membranes.

RubberCover Bonding Adhesive BA-2012

Solvent-based contact adhesive designed specifically for bonding RubberCover EPDM membranes to approved insulations in addition to wood, metal, masonry and other acceptable substrates.

RubberCover Bonding Adhesive BA-2016 S/TF

Sprayable solvent-based contact adhesive specifically designed for bonding RubberCover EPDM membranes to approved insulations in addition to wood, metal, masonry and other acceptable substrates.

Cleaner C-20

Alcohol-based degreaser with extremely fast evaporation properties, designed for efficiently removing all types of Elevate adhesives, sealants and other types of contamination from EPDM membranes, metal and many other solvent-resistant surfaces.

Tools

We provide you with the right professional tools for a quality installation of the RubberCover EPDM roofing system.

Spray gun and hose

Professional spray gun with extension, to be used in combination with the 4 m rubber hose. Both products are specifically designed to spray Elevate adhesives.

QuickScrubber pad and handle

Used for the application of the QuickPrime Plus primer.

Silicone rubber roller

Used for rolling seams and installation details after the application of QuickSeam products.